Hands-free unit HF-15
The hands-free unit has the following connectors. The symbols are
printed at the bottom of the unit.
•
—Connector for the microphone MP-2
•
—Mono audio output for the loudspeaker SP-3
•
—Connector for the input device CU-8
•
—Connector for the display unit SU-29
•
—Dc power connector for the power cable PCU-4
When you install the hands-free unit, ensure that the cables for the
display unit, microphone, and loudspeaker reach the places where you
intend to mount these parts.
I n s t a l l a t i o n
26
Do not mount the hands-free unit inside a metal housing or on a metal
surface because this will impair the Bluetooth connection between the
hands-free unit and the Bluetooth device that is connected to the car
kit. For an optimal connection, ensure that the distance between the
hands-free unit and a metal surface is over 4 mm (0.16 inch).
To mount the hands-free unit, use the hook and loop tape pads supplied
with the car kit in the same way as with the input device (see the figures
in “Input device CU-8,” p. 26). Detach the two pads from each other.
Attach the pad with the loops first: peel off the protective sheet from
the adhesive side, and attach the pad to the desired location in the car.
When you peel off the protective sheet, do not touch the adhesive side
with a finger. Ensure that the surface where you attach the pad is dry
and free from dirt and dust.
To attach the pad with the hooks, peel off the protective sheet from the
adhesive side, and attach the pad to the underside of the hands-free
unit.
Press the hands-free unit firmly onto the loop pad, and check that the
hands-free unit stays securely in place.